Hi
These are bespoke Titanium Exhaust Manifold Studs and were made from Ti6Al4V which is stronger than pure Ti but retain the same stiffness. It will never, ever rust, rot, corrode or do anything other than remain a stud.
These were made by PopBangBang (on this forum). I no longer need these.
M8 X 45mm. 15mm Thread on one end, 10mm shank and 20mm thread on the other end. Have used these as exhaust manifold studs on my 996 and they provide 10mm additional thread beyond a standard aerospace M8 K-Nut without washer. These will fit Turbo and GT3 as far as we can make out as they are all on the same fastener accordingly to the Porsche parts book. The extra length makes installation of the nut much easier and doesn't hamper installation.
For 996 Turbo you'll need 18 studs (9 per side) and 18 washers.
£150 incl postage.
:thumbs: [/url]
These are bespoke Titanium Exhaust Manifold Studs and were made from Ti6Al4V which is stronger than pure Ti but retain the same stiffness. It will never, ever rust, rot, corrode or do anything other than remain a stud.
These were made by PopBangBang (on this forum). I no longer need these.
M8 X 45mm. 15mm Thread on one end, 10mm shank and 20mm thread on the other end. Have used these as exhaust manifold studs on my 996 and they provide 10mm additional thread beyond a standard aerospace M8 K-Nut without washer. These will fit Turbo and GT3 as far as we can make out as they are all on the same fastener accordingly to the Porsche parts book. The extra length makes installation of the nut much easier and doesn't hamper installation.
For 996 Turbo you'll need 18 studs (9 per side) and 18 washers.
£150 incl postage.
:thumbs: [/url]