Hi guys. One of my turbo actuator rods has popped off its ball joint. Can see it clearly(ish) and can just about manoeuvre it with finger tips. Can anyone give me a tip as to how to actually lever it back on?
I don't have access to a lift but am able to reverse it so the back of the car protrudes over about a 1 foot high drop to my neighbours driveway where I can look underneath - so working room is limited. I suspect this is the root of my problem in refixing it.
Its going to be replaced when in for service soon but would like it useable until then.
Thanks.
I don't have access to a lift but am able to reverse it so the back of the car protrudes over about a 1 foot high drop to my neighbours driveway where I can look underneath - so working room is limited. I suspect this is the root of my problem in refixing it.
Its going to be replaced when in for service soon but would like it useable until then.
Thanks.