Hi All,
I'm replacing gaskets for both upper and lower valve covers.
I'd read how the drivers side upper, could be a pain to access, but after removing the clutch vent pipe etc. removing the engine tray went fine, so access to the driver side covers seems fine.
Now trying to remove the passenger side engine tray, I'm stuck on how to get at the last two bolts which basically face the passenger seat?
I have lowered the suspension arm a little, which gives a bit better access, is that the way to go?
I still can't get a good fix on either bolt.
I'm replacing gaskets for both upper and lower valve covers.
I'd read how the drivers side upper, could be a pain to access, but after removing the clutch vent pipe etc. removing the engine tray went fine, so access to the driver side covers seems fine.
Now trying to remove the passenger side engine tray, I'm stuck on how to get at the last two bolts which basically face the passenger seat?
I have lowered the suspension arm a little, which gives a bit better access, is that the way to go?
I still can't get a good fix on either bolt.