Following on from the thread in the 997 section:
http://www.911uk.com/viewtopic.php?t=127757&postdays=0&postorder=asc&start=0
I have a vested interest as I am looking to buy a smaller plate for the front too, my plinth is 44cm and 8cm approx.
I was going to go for a normal height plate but cut down to 44cm :dont know:
I have the 996 plinth, part number 996.701.105.00:
Size:
If using plinth/screws method then you could use a 33-34cm plate:
If you want to mount on the holes 27cm:
Standard plate looks a bit too big for me (I will take a front end shot and replace this one):
:thumb:
http://www.911uk.com/viewtopic.php?t=127757&postdays=0&postorder=asc&start=0
I have a vested interest as I am looking to buy a smaller plate for the front too, my plinth is 44cm and 8cm approx.
I was going to go for a normal height plate but cut down to 44cm :dont know:
I have the 996 plinth, part number 996.701.105.00:
Size:
If using plinth/screws method then you could use a 33-34cm plate:
If you want to mount on the holes 27cm:
Standard plate looks a bit too big for me (I will take a front end shot and replace this one):
:thumb: