I am replacing plugs and coils on my 996tt. I purchased 6 beru coils from ECP and they are all the large headed 997 ones. I noticed on site some discussion about them not fitting in all locations, cylinder #5 being an issue. On closer inspection, it would appear the coil pack might well be touching the hard pipe that kinks right near cylinder #5, if it isn't touching its only the thickness of a sheet of paper away. I have now purchased another coil, with the smaller head that should fit no problem in this location. However, this is a bremi coil. Should this be a problem? Or should I leave the large coil in place? I didn't have any issues getting it in place, its just a little close for comfort.