Picked up a new pair of Rennline Semi-solid engine mounts yesterday, which will hopefully be fitted in the next few weeks, together with the tubi exhaust and eibach springs... I can't wait!!
Unboxing everything and reading through the rather "light" instructions, i still have a question and i was hoping someone who was fitted them could advise
How do i make sure that when i tighten up the bottom nut (red), the square end of the nut is correctly aligned with the upper holes (green) so that it fits in the car?
Also, rennline recommend using red loctite for the 134mm stud, anyone done it without?
Any help/advise much appreciated!
Unboxing everything and reading through the rather "light" instructions, i still have a question and i was hoping someone who was fitted them could advise
How do i make sure that when i tighten up the bottom nut (red), the square end of the nut is correctly aligned with the upper holes (green) so that it fits in the car?
Also, rennline recommend using red loctite for the 134mm stud, anyone done it without?
Any help/advise much appreciated!