http://www.design911.co.uk/index.htm?Region=UK
:
964/993 LIGHT WEIGHT CLUTCH KIT
[url='javascriptarent.cartcookie.additem(Document.ID964822101RS,964/993]
[/url]
Complete RS lightweight single-mass flywheel and clutch conversion package to replace the heavy and unreliable dual-mass set up, reduce the rotational inertia of the crankshaft assembly and provide lightning engine response & acceleration. Our comprehensive kit has all the components required to install the RS Clubsport flywheel and clutch onto any 3.6 engine, Whats so good ? lighter in weight, faster pick up out off turns resulting in reduced laptimes of up to 2 seconds per lap The package consists of1 x RS Flywheel 9 x Flywheel to crankshaft bolt 1 x Clutch centre plate 1 x Clutch pressure plate 1 x Clutch release bearing 1 x Flywheel spigot bearing (nose bearing for gearbox input shaft)1 x RS starter ring gear 1 x Guide tube for release bearing 9 x Clutch cover to flywheel bolt
ID964822101RS
£ 695.00
Any good? Worth it?
There seems to be a few passing references to it on various posts here, but no categoric "yes" or "no". What's the benefits / any downsides? Worth doing for a car that will be predominantly road (not track) based?
Migration info. Legacy thread was 17676
:
964/993 LIGHT WEIGHT CLUTCH KIT
[url='javascriptarent.cartcookie.additem(Document.ID964822101RS,964/993]
Complete RS lightweight single-mass flywheel and clutch conversion package to replace the heavy and unreliable dual-mass set up, reduce the rotational inertia of the crankshaft assembly and provide lightning engine response & acceleration. Our comprehensive kit has all the components required to install the RS Clubsport flywheel and clutch onto any 3.6 engine, Whats so good ? lighter in weight, faster pick up out off turns resulting in reduced laptimes of up to 2 seconds per lap The package consists of1 x RS Flywheel 9 x Flywheel to crankshaft bolt 1 x Clutch centre plate 1 x Clutch pressure plate 1 x Clutch release bearing 1 x Flywheel spigot bearing (nose bearing for gearbox input shaft)1 x RS starter ring gear 1 x Guide tube for release bearing 9 x Clutch cover to flywheel bolt
ID964822101RS
£ 695.00
Any good? Worth it?
There seems to be a few passing references to it on various posts here, but no categoric "yes" or "no". What's the benefits / any downsides? Worth doing for a car that will be predominantly road (not track) based?
Migration info. Legacy thread was 17676