jackthelad
New member
- Joined
- 19 May 2015
- Messages
- 2
Hi guys,
I am having a few issues with door locks on my 911 SC ; I had to get the lock Dr out to open the drivers side.
The passenger side door will only open from the inside and when I was trying to service, lubricate it after taking off the door card the lock stopped working ! But I think its the lock mechanism not working correctly.
Is there an easy solution as taking the units out apparently involves removing the window frame and window guide !
Would it be a good idea to clean it in situ with engine degreaser and lubricate it with lithium grease as there is a build up years of previous grease. Could this be the potential problem rather than taking the window frame out with the lock mechanism ?
Can they be serviced or should the 36 year old unite be replaced ? (cost !)
Thanks in advance.
I am having a few issues with door locks on my 911 SC ; I had to get the lock Dr out to open the drivers side.
The passenger side door will only open from the inside and when I was trying to service, lubricate it after taking off the door card the lock stopped working ! But I think its the lock mechanism not working correctly.
Is there an easy solution as taking the units out apparently involves removing the window frame and window guide !
Would it be a good idea to clean it in situ with engine degreaser and lubricate it with lithium grease as there is a build up years of previous grease. Could this be the potential problem rather than taking the window frame out with the lock mechanism ?
Can they be serviced or should the 36 year old unite be replaced ? (cost !)
Thanks in advance.