Don't fanny around with hacksaw blades, I did that took me absolutely ages.
A tip I read somewhere (after doing the job) is to use a drill to drill through the coffin arm and bolt as near to the edge of the arm as you can get. Do it at either end, bits of remaining bolt should come out then.
Otherwise ... reciprocal saw? careful of your subframe though.
A tip I read somewhere (after doing the job) is to use a drill to drill through the coffin arm and bolt as near to the edge of the arm as you can get. Do it at either end, bits of remaining bolt should come out then.
Otherwise ... reciprocal saw? careful of your subframe though.