http://www.designtek.eu/Air-Induction-Kit-for-Porsche-996TT-DesignTek-Cold-Air-System/prod17315/
Came off my car when it was put back to stock for resale - here is the blurb from the web site
DesignTek intake kit is high quality molded aluminum boxes powdercoated in high temperature black texture. Using a CNC machined 6061 aluminum MAF housing, the air flow stays consistent and without any check engine lights using our air flattener mesh before the sensor. Connecting the two boxes together is a 3.5 inch diameter silicone tube. The air flows well with a K&N cone filter that comes pre-oiled and will last you almost 10,000 miles before you have to clean it. The filter is sealed in the left box to keep it cool from engine heat. As tested under street and highway conditions, the air inside the box stays approximately 5-10F degrees cooler then the engine compartment air. Designtek intake achieves an impressive 32 wheel horsepower and 22 ft/lbs of torque in strong points of the RPM range. Peak numbers are 21 ft/lbs of torque and 7 wheel horsepower. This intake kit fits both the standard 996TT and the X50 package. It can be used with the factory decklid or the GT2 rear decklid.
Fits 996 Turbo and GT2.
£500 new - make me an offer if you are interested!
Thanks
Mike
Came off my car when it was put back to stock for resale - here is the blurb from the web site
DesignTek intake kit is high quality molded aluminum boxes powdercoated in high temperature black texture. Using a CNC machined 6061 aluminum MAF housing, the air flow stays consistent and without any check engine lights using our air flattener mesh before the sensor. Connecting the two boxes together is a 3.5 inch diameter silicone tube. The air flows well with a K&N cone filter that comes pre-oiled and will last you almost 10,000 miles before you have to clean it. The filter is sealed in the left box to keep it cool from engine heat. As tested under street and highway conditions, the air inside the box stays approximately 5-10F degrees cooler then the engine compartment air. Designtek intake achieves an impressive 32 wheel horsepower and 22 ft/lbs of torque in strong points of the RPM range. Peak numbers are 21 ft/lbs of torque and 7 wheel horsepower. This intake kit fits both the standard 996TT and the X50 package. It can be used with the factory decklid or the GT2 rear decklid.
Fits 996 Turbo and GT2.
£500 new - make me an offer if you are interested!
Thanks
Mike